Go to the beach and collecting is a wonderful hobby. Many people join in to make seashell jewelry or wind chimes. Whatever you plan to do, you may need to stick a hole in it to hang it on a wire or chain. Stick a shell is not very difficult and with some patience, you break a few of them. Before sticking your favorite using a drill, try practicing in other not so important shells.
Directions for make seashell jewelry: 1) Soak the shells in a bucket of warm water and detergent for 20 to 30 minutes. Wash them to remove sand, dirt and debris – you can use a soft bristle brush for this. Rinse the soapy water from their shells and let the wind dry. 2) With a marker or thin and soft tip pencil, make a point where you want to drill a hole. Make the point on the front – where the Chip shell while you punch, will be at the back of the shell. 3) With care, the shell secures with the lathe or clip. You need it locks not to move in the drill. 4) Use a drill to ceramics. Start with the smallest of them and hold your drill perfectly vertical way. 5) Drill slowly easing and increasing the pressure. Stop sticking to the Cools drill and start again – this will prevent the seashell jewelry break.